CP010 Electronic Measuring System Car‑O‑Tronic Vision2 X3

A two day course on the Electronic Measuring System Car-O-Tronic Vision2 X3 for collision repair technicians, covering methods and equipment for setting up and measuring a damaged vehicle. Included are lower and upper body measuring, and using vehicle data sheets.

 

COURSE OVERVIEW

Target group:
Collision Damage repair technicians who
want more knowledge about the repair
process and training on computerized measuring systems

Previous training:
No previous training required

Objectives:
After completion of the course, the participant should have knowledge of:

  • understanding the different steps in the repair process
  • how to set up the car on the bench
  • how to find, read and use the data sheet
  • how to make a diagnosis of the damage, to complete the damage documentation and to send the damage report by e-mail
  • how to fully use the electronic measuring system for lower and upper body measurement, and absolute and comparative measuring
  • how to center and measure a car without a data sheet

Equipment:

  • BenchRack or Quick 42
  • Draw aligner
  • Electronic measuring system Car-O-Tronic Vision2 X3
  • EVO 1-3
  • Damaged vehicle

Duration:
Two full days, 16 hours

 

COURSE CONTENT

Personal protective equipment:

  • Information on personal protective equipment
  • The environment and safety

Theory and practice- Car-O-Tronic:

  • Review of Car-O-Tronic Software Vision2 X3
  • Data sheet from check-up list
  • Data sheet from Internet with web access
  • Tolerances and measurement values for car bodies

Theory and practice – mounting cars on benches:

  • Methods for different types of damage
  • Attaching the chassis clamps

Theory and practice – Centering:

  • Which measuring points are used
  • Alternative centering
    • Two-point centering
    • Centering without data sheet

Theory and practice – Measuring:

  • Low measuring points
  • High measuring points
  • Absolute measuring
  • Comparative measuring
  • Measuring wheel suspension
  • Surface measuring
  • Point-to-point measuring

Theory and practice – Analysis:

  • Simple damage analysis

Theory and practice – Draw aligner and dolly kit:

  • Arm and vector draw aligners
  • Dolly kits: EVO1-2
  • Universal holding and fixture system: EVO 3
  • Practical work, drawing and aligning techniques

Theory and practical presentation of results:

  • Reports, printouts for different purposes